Comtech EF Data LPOD Spezifikationen Seite 114
- Seite / 218
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC) MN-LPOD
Serial-based Remote Product Management Revision 10
5–14
Parameter Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are printable ASCII characters)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to Query
(Target to
Controller)
Concise
Configuration
Status
N/A
26 bytes
Query only.
This is the concise version of the RCS query. Returns the configuration status of the unit, in the form
aa.aa;b;c;d;e;ff.ff;g;hhh, where:
aa.aa = attenuation in dB (ATT)
b = RF power amplifier state, 0 = Off, 1 = On (AMP)
c = mute state, 0 = un-muted, 1 = muted (MUT)
d = online status (ONL)
e = redundancy state and mode (ESW)
ff.ff = Attenuator offset in dB (AOF)
g = auto fault recovery mode (AFR)
hhh = External reference status, N/A = no external reference, 05M for 5 MHz, and 10M for a 10 MHz (See
Note)
Note: hhh will always be N/A if the internal reference oscillator option is not installed.
Example: CCS=aa.aa;b;c;d;e;ff.ff;g;hhh; ’cr’’lf’
CCS=
CCS?
CCS= aa.aa;b;c;d;e;
ff.ff;g;hhh
(See Description of
Arguments)
Concise RF Power
FET Current
Status
N/A
Length varies
depending on
number of
FETs installed
in the amplifier
Query only.
This is the concise version of the RFS query. Returns the RF Power FET Current status.
Example: CFS=xxx,xxx,x.x,x.x,……….,x.x,
CFS=
CFS?
CFS=x…..x
(See description of
RFS. Note that each
argument is
separated by a
comma.)
Circuit
Identification
CID=
48 bytes
Command or Query.
Sets or returns a 48-byte user-defined string that identifies or names the unit or station. The CID is entered as
one line, but it reads back from the unit as two 24-byte lines of data.
Default value: ------------------------
Examples:
<1/CID= Station #001--SSPA #01--’cr’
>0001/CID=
<1/CID?’cr’
>0001/CID=’cr’
Station #001’cr’
--SSPA #01--’cr’’lf’
CID=
CID?
CID*
CID?
CID=x…x
(See Description of
Arguments)
- Revision 10 1
- Part Number MN-LPOD 3
- Revision 10 3
- TABLE OF CONTENTS 5
- vii 9
- FIGURES 10
- PREFACE 13
- Electrical Safety Notice 14
- Product Support 15
- Preface Revision 10 16
- Chapter 1. INTRODUCTION 19
- 1.2 Functional Description 20
- 1.3 Features 20
- 1.3.7 Optional LNB Support 21
- 1.4 Theory of Operation 22
- 1.4.1 SSPA Block Diagrams 22
- 1.4.2 SSPA Module 23
- 1.4.3 Cooling System 24
- 1.4.5 LNB Operation 24
- 1.4.6 Power Supply 24
- BUC C, Ku, X LO Frequencies 25
- 1.5.1 Characteristics 26
- 1.5.4 Environmental 28
- 1.5.5 Physical 28
- 1.6 Dimensional Envelopes 30
- Introduction Revision 10 31
- Chapter 2. SYSTEM 41
- CONNECTIONS, INSTALLATION 41
- STARTUP 41
- 2.3 Interface Connectors 44
- Control Port) 48
- 2.3.8 Ground Connector 49
- 2.5 Power-up the LPOD 50
- Chapter 3. UPDATING FIRMWARE 55
- Chapter 4. ETHERNET-BASED 65
- REMOTE PRODUCT 65
- 4.3 SNMP Interface 66
- 4.3.3 SNMP Traps 67
- 4.4 Telnet Interface 70
- Enter the LPOD’s 71
- 4.5.2 User Login 73
- 4.5.3.1 Menu Tree 74
- 4.5.3.2 Page Navigation 74
- 4.5.3.3 Page Sections 74
- 4.5.3.4 Action Buttons 75
- 4.5.3.5 Drop-down Lists 75
- 4.5.3.6 Text or Data Entry 75
- 4.5.4.1 Home Pages 76
- 4.5.4.1.1 Home 76
- 4.5.4.1.2 Home 77
- 4.5.4.1.3 Home 78
- 4.5.4.2 Admin Pages 79
- 4.5.4.2.1 Admin 79
- Webpage Timeout 80
- 4.5.4.2.2 Admin 81
- 4.5.4.3 Config Pages 82
- 4.5.4.3.2 Config 84
- 4.5.4.3.3 Config 85
- Redundancy 87
- Online Status 87
- Force Online 87
- 4.5.4.4 Status Pages 88
- 4.5.4.4.1 Status 88
- 4.5.4.4.2 Status 89
- 4.5.4.4.3 Status 90
- 4.5.4.4.4 Status 91
- Alarm Mask 92
- Statistics Configuration 94
- 4.5.4.4.6 Status 95
- Control Bar and Refresh Tab 96
- Temperature Graph 97
- Power Graph 97
- LNB Current Graph 98
- Amplifier Status Graph 98
- Mute State Graph 98
- Online Status Graph 99
- Minimum Fan Speed Graph 99
- MANAGEMENT 101
- 5.2.2 Attenuator Control 102
- 5.2.3 Mute Control 102
- 5.2.4 Faults 102
- 5.2.5 Power Detector 104
- 5.2.6 Some Common Commands 104
- 5.2.7 End-of-Life Commands 104
- 5.1.1 EIA-485 105
- 5.1.2 EIA-232 106
- 5.1.3 Basic Protocol 106
- 5.1.4 Packet Structure 106
- 5.1.4.1 Start of Packet 107
- 5.1.4.2 Target Address 107
- 5.1.4.3 Address Delimiter 107
- 5.1.4.4 Instruction Code 108
- 5.1.4.7 End of Packet 109
- Appendix A. 1:1 REDUNDANCY 137
- Appendix A Revision 10 138
- A.5.1 Common Kit Examples 146
- BLANK PAGE 151
- Appendix B. CABLE DRAWINGS 193
- B.2 Control and Data Cables 194
- Appendix B Revision 10 195
- B.3 RF Cables 202
- B.3.1 RF Cable (Type ‘N’) 203
- Appendix C. MAINTENANCE 205
- Appendix C Revision 10 206
- 212
- 480 • 333 • 2200 PHONE 218
- • 333 • 2161 FAX 218
Verwandte Produkte und Handbücher für Audioverstärker Comtech EF Data LPOD
Recon 264140BK & CL LED Mirror Lenses (Ford) podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Do samochodu Recon 264140BK & CL LED Mirror Lenses (Ford).
Dostarczamy 1 pdf podręczników Recon 264140BK & CL LED Mirror Lenses (Ford) do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Recon 264140BK & CL LED Mirror Lenses (Ford) Instrukcja Użytkownika (2 strony)
Marka: Recon | Kategoria: For the car | Rozmiar: 0.09 MB |
Spis treści
Więcej produktów i instrukcji dla Do samochodu Recon
| Modele | Rodzaj dokumentu |
|---|---|
| 264146 RAM Cab Light (Dodge) |
Instrukcja Użytkownika
RECON 264146 RAM Cab Light (Dodge) User Manual,
16 strony
|
| Illuminated Door Sills |
Instrukcja Użytkownika
RECON Illuminated Door Sills User Manual,
1 strony
|
| 264241BK & CL Mirror Lenses (Ford) |
Instrukcja Użytkownika
RECON 264241BK & CL Mirror Lenses (Ford) User Manual,
2 strony
|
| LED Tail Lights (2008+ Ford Superduty) |
Instrukcja Użytkownika
RECON LED Tail Lights (2008+ Ford Superduty) User Manual,
2 strony
|
| LED Bulbs & Accessories |
Instrukcja Użytkownika
RECON LED Bulbs & Accessories User Manual,
1 strony
|
| Illuminated Emblems |
Instrukcja Użytkownika
RECON Illuminated Emblems User Manual,
1 strony
|
| 264150 - How To Replace H3 Bulb |
Instrukcja Użytkownika
RECON 264150 - How To Replace H3 Bulb User Manual,
1 strony
|
| 26417 Bed Rail Light Kit |
Instrukcja Użytkownika
RECON 26417 Bed Rail Light Kit User Manual,
14 strony
|
| 264150 Backup Projector Lamps DIY |
Instrukcja Użytkownika
RECON 264150 Backup Projector Lamps DIY User Manual,
7 strony
|
| 264135BK & CL Round Fender Lenses (Jeep Wrangl |
Instrukcja Użytkownika
RECON 264135BK & CL Round Fender Lenses (Jeep Wrangler JK) User Manual,
9 strony
|
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.034 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern