Comtech EF Data CDM-700 Spezifikationen Seite 192
- Seite / 266
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
CRS-300 1:10 Redundancy Switch Revision 16
Front Panel Operation MN/CRS300.IOM
7–12
EDIT SWITCH BUS ADDRESS:
3000 (PRESS ENTER)
The value of the address is changed using the ▲ ▼ arrow keys. The User should then press [ENT].
Note: This setting does not affect the internal communications between the Switch and the modems.
7.4.5 CONFIG: ACTIVE (Active Modems)
ACTIVE MODEMS: (ENTER)
1 2 3 - 5 6 - 8 9 10
Select which Traffic Modems to activate. Use the ◄ ► arrow keys to select the modem, then use
the ▲ ▼ arrow keys to activate or deactivate the modem.
An hyphen (-) appears in place of the modem number if it is deactivated. If a Traffic Modem
interface is not plugged into a slot, that position cannot be activated. A modem must be active in
order for it to be available to bridge or backup. Once activated, the Switch will expect a modem
to be attached, and will poll the modem for status information.
When adding or removing a modem in an operating 1:N Switch system, it is important to keep the
traffic safe, by preventing any contention in the system from an unsuppressed modem Tx carrier.
To add an additional Traffic Modem:
• Attach control, data and IF cables as outlined in
Chapter 4. CABLES AND CONNECTIONS.
• Configure the modem and Switch as outlined in
Chapter 5. MODEM, RMI/TMI, AND
SWITCH CONFIGURATION.
To remove a Traffic Modem that is not being backed-up
:
• De-activate the modem from the Switch configuration (CONFIG: ACTIVE, ▼ arrow for
the appropriate TMI/modem position).
• Power-down the modem.
• Detach all cables.
To replace a faulted Traffic Modem that is being backed-up
by the Redundant:
• Detach the IF cables of the faulted modem.
• Power-down the modem.
• Remove all other the cables and remove the modem.
• Install the replacement modem.
• Attach the power cord and power up the modem.
• Attach control, data and IF cables as outlined in Chapter 4. CABLES AND
CONNECTIONS.
• Configure the modem as outlined in Chapter 5. MODEM, RMI/TMI AND SWITCH
CONFIGURATION.
• The new Traffic Modem should lock as it is bridging the Redundant Modem. The Switch
will then ready and able to cope with any other fault that may occur.
CAUTION
Do not deactivate this modem, as the traffic path must be maintained.
- CRS-300 1
- Table of Contents 5
- Figures 13
- PREFACE 17
- Preface MN/CRS300.IOM 18
- EN55024 - 1998 Compliance 19
- Safety Compliance 19
- EN 60950 19
- Low Voltage Directive (LVD) 19
- Warranty Policy 20
- Limitations of Warranty 20
- Exclusive Remedies 21
- Customer Support 22
- Online Customer Support 22
- Chapter 1. INTRODUCTION 23
- Introduction MN/CRS300.IOM 24
- 1.2 CRS-300 Compatibility 26
- 1.4.1 Front Panel 29
- 1.4.2 Rear Panel 30
- SLM-5650/5650A 33
- 1.6.5 Dimensional Envelopes 41
- Chapter 2. INSTALLATION 45
- Installation MN/CRS300.IOM 46
- Chapter 4 61
- CABLES AND CONNECTIONS 61
- 4.5.2 Carrier-in-Carrier 82
- (CnC) Data Connections 82
- Cable Connection Example 83
- Note 1 89
- Notes 2,3 89
- Emulation Mode 96
- MPORTANT 100
- Chapter 3. ETHERNET NETWORK 112
- CONFIGURATIONS 112
- Chapter 3. ETHERNET 127
- NETWORK CONFIGURATIONS 127
- IMPORTANT 133
- 4.11 IF Cable Connections 139
- 4.11 IF Cable Connections 140
- IMPOR TANT 145
- 5.2 Modem Configuration 146
- 5.2.1 Modem Power 146
- 5.2.2.1 Flash Updating 146
- Processor (NP) Interface 150
- Slot 1 Mod 152
- Slot 2 Demod 152
- Slot 3 Mod 152
- Slot 4 Demod 152
- Tables 5-2 throu 155
- Rev. F. and later versions; 158
- Rev. D and later versions 158
- CA and TA 161
- 5.5 Switch Configuration 162
- 5.5.1 Switch Power 162
- 5.5.2 Flash Updating 163
- 5.5.2.1.1 Flash Update Help 165
- 5.5.3.4 Set Holdoff Period 167
- 5.5.3.5 Set Alarm Masking 168
- User Clock/Data Interface: 174
- IDR ESC Interface connector 174
- TMI User Data Interface: 174
- ASI connectors 174
- Unbalanced G.703 connectors 176
- Quad E1 connectors 179
- Chapter 7. FRONT PANEL 181
- OPERATION 181
- 7.1.4 Opening Screen 185
- 7.2 CRS-300 Menu Structure 186
- 7.4.1 CONFIG: MANUAL 188
- 7.4.3 CONFIG: OPTIONS 189
- 7.4.4 CONFIG: REMOTE 191
- 7.5.1 INFO: S/N 193
- 7.5.2 INFO: ID 193
- 7.5.3 INFO: SETUP 193
- 7.5.4 INFO: IF-SWITCH 193
- 7.6 SELECT: MONITOR 194
- 7.6.1 MONITOR: STATUS 194
- 7.6.2 MONITOR: SW-ALARM 195
- 7.6.5 MONITOR: IO 198
- 7.7.1 STORE/LD: STORE 199
- 7.7.2 STORE/LD: LOAD 199
- 7.8 SELECT: UTILITY 200
- 7.8.3 UTILITY: SWITCH-ID 200
- 7.8.4 UTILITY: TEST 201
- 7.8.5 UTILITY: RELAY 201
- Appendix A. CABLE DRAWINGS 203
- A.3 Control Cables 207
- USED WITH CRS-300 Æ … 218
- Chp. 4 FIG USED FOR (TYPE) 218
- Chapter 4.7 230
- CDM-700 Modem Connections 230
- A.4.14 IF Cable, BNC 50Ω 232
- A.4.16 Multi-drop CnC 234
- Appendix B. ADDRESSING 239
- SCHEME INFORMATION 239
- B.2 Switch Addresses 240
- 1:1 internal 243
- Slave mode is available 243
- 1.6.2 or later 243
- B.3.1 Setting Up Modems 249
- B.4 M&C Applications 250
- Appendix C. REMOTE CONTROL 251
- C.3 EIA-232 252
- C.4 Basic Protocol 252
- C.5 Packet Structure 253
- C.5.1 Start of Packet 253
- C.5.2 Target Address 253
- C.5.3 Address Delimiter 254
- C.5.4 Instruction Code 254
- C.5.7 End of Packet 256
- 480 • 333 • 2200 PHONE 266
- • 333 • 2161 FAX 266
Verwandte Produkte und Handbücher für Vernetzung Comtech EF Data CDM-700
Whirlpool IB 7030 A1 D.UK podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Zamrażarki Whirlpool IB 7030 A1 D.UK.
Dostarczamy 2 pdf podręczników Whirlpool IB 7030 A1 D.UK do pobrania za darmo według typów dokumentów: Podręcznik Użytkownika
Whirlpool IB 7030 A1 D.UK Podręcznik Użytkownika (2 strony)
Marka: Whirlpool | Kategoria: Freezers | Rozmiar: 0.46 MB |
Spis treści
Whirlpool IB 7030 A1 D.UK Podręcznik Użytkownika (2 strony)
Marka: Whirlpool | Kategoria: Freezers | Rozmiar: 0.52 MB |
Spis treści
Więcej produktów i instrukcji dla Zamrażarki Whirlpool
| Modele | Rodzaj dokumentu |
|---|---|
| LC39 |
Instrukcja Obsługi
Whirlpool LC39 Instruction for Use,
4 strony
|
| AFB 436/G |
Instrukcja Obsługi
Whirlpool AFB 436/G Instruction for Use,
9 strony
|
| WBE33352 NFC W | Instrukcja Obsługi Whirlpool KGN 3382 A+ FRESH IL Instruction for Use, 10 strony |
| SW8 AM2C KAR | Instrukcja Użytkowania i Eksploatacji Whirlpool SW8 AM2C KAR Health and safety, 4 strony |
| ES 505 | Instrukcja Obsługi Whirlpool TG 400 A+ Instruction for Use [es] , 4 strony |
| MUF1027TXGS |
Instrukcja Obsługi
Whirlpool MFU0824TXGWUP FR Instruction for Use,
9 strony
|
| ARC 6680 | Instrukcja Obsługi Whirlpool ARC 6170 Instruction for Use, 15 strony |
| LR6 S1 W | Poradnik Użytkowania i Eksploatacji Whirlpool LR6 S1 W Use and care guide [ua] , 24 strony |
| WTS4445 A+NFX | Instrukcja Obsługi Whirlpool WTS4445 A+NFW Instruction for Use [fr] , 18 strony |
| WV1843 X |
Instrukcja Obsługi
Whirlpool WV1843 X Instruction for Use,
20 strony
|
| ARC 8140/AL |
Instrukcja Obsługi
Whirlpool ARC 8140 Instruction for Use,
20 strony
|
| SW8 AM2C KAR | Poradnik Użytkowania i Eksploatacji Whirlpool SW8 AM2C KAR Use and care guide, 12 strony |
| KCFMA 60150R | Instrukcja Użytkowania i Eksploatacji Whirlpool KCFMA 60150R Health and safety, 2 strony |
| BSNF 8121 W | Poradnik Użytkowania i Eksploatacji Whirlpool BSNF 8121 W Use and care guide [fr] , 33 strony |
| BSNF 8752 W | Poradnik Użytkowania i Eksploatacji Whirlpool BSNF 8752 W Use and care guide, 35 strony |
| ART 465/R | Instrukcja Obsługi Whirlpool KGI 2951/A Instruction for Use [en] , 9 strony |
| UVI 1349/A-LH | Instrukcja Obsługi Whirlpool UVI 1340/A/1 Instruction for Use [es] , 8 strony |
| EN 5304 B/E02 | Instrukcja Obsługi Whirlpool CIV-22/UK Instruction for Use [en] , 7 strony |
| BSNF 9152 W | Poradnik Użytkowania i Eksploatacji Whirlpool BSNF 9152 W Use and care guide, 26 strony |
| SBD 2012 IZF/HA |
Instrukcja Obsługi
Whirlpool SBD 2012 IZF/HA Instruction for Use,
24 strony
|
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.072 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern