Comtech-ef-data OMS11 Bedienungsanleitung

OMS11 Outdoor Modem Switch Installation and Operation Manual TM133 Revision 1.1 Comtech EF Data • 2114 W 7th St. • T

OMS11 1:1 Redundancy Switch Table of Contents TM133 – Rev. 1.1 3 Section 7 - Technical Specifications ...

Introduction OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 4

OMS11 1:1 Redundancy Switch Introduction TM133 – Rev. 1.1 1-1 Introduction 1 1.0 Description The Radyne OMS11 Outdoor Modem Switch provides re

Introduction OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 1-2 1.2 Front Panel Controls The Front Panel of the OMS11 provides all of the nece

OMS11 1:1 Redundancy Switch Introduction TM133 – Rev. 1.1 1-3

OMS11 1:1 Redundancy Switch Theory of Operation TM133 – Rev. 1.1 2-1 Theory of Operation 2 2.0 Theory of Operation The Radyne OMS11 Outdoor Mod

Theory of Operation OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 2-2 2.1.1 Operating Procedures The OMS11 is designed to require minimal ope

OMS11 1:1 Redundancy Switch Theory of Operation TM133 – Rev. 1.1 2-3 2.2 OMS11 Major Assemblies The OMS11 Redundancy Control Unit contains the mo

Theory of Operation OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 2-4 If Power Supply 1 and Power Supply 2 simultaneously fail, the switching c

OMS11 1:1 Redundancy Switch Warranty Policy TM133 – Rev. 1.1 iii Warranty Policy WP Comtech EF Data products are warranted against defects in ma

OMS11 1:1 Redundancy Switch Theory of Operation TM133 – Rev. 1.1 2-5

OMS11 1:1 Redundancy Switch User Interfaces TM133 – Rev. 1.1 3-1 User Interfaces 3 3.0 User Interfaces These are:  Front Panel Interface –

User Interfaces OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 3-2 SELECT Modem A (Pushbutton) -------------------- Allows the operator to selec

OMS11 1:1 Redundancy Switch User Interfaces TM133 – Rev. 1.1 3-3

OMS11 1:1 Redundancy Switch Installation TM133 – Rev. 1.1 4-1 Installation 4 4.0 Installation Requirements The diagrams in this section displ

Installation OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 4-2  OMS11 1:1 Redundancy Switch Unit  Two AC or DC Mating connectors (J6 &

OMS11 1:1 Redundancy Switch Installation TM133 – Rev. 1.1 4-3 PROPER GROUNDING PROTECTION: During installation and setup, the user must ensure th

Installation OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 4-4 Figure 4-1 Antenna Mounting Kit Item Radyne P/N Description 1 FP5914-2 UNI

Warranty Policy OMS11 1:1 Redundancy Switch iv TM133 – Rev. 1.1 Warranty Repair Return Procedure Before a warranty repair can be accomplished

OMS11 1:1 Redundancy Switch Installation TM133 – Rev. 1.1 4-5 Figure 4-2 Antenna Mount Front View on King Post NOTE: All connections are fa

Installation OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 4-6 Figure 4-3 Antenna Mount Bottom View Cable Connects OMS11 Location Modem

OMS11 1:1 Redundancy Switch Installation TM133 – Rev. 1.1 4-7 Figure 4-4 BUC Mount Front View on King Post NOTE: Reference only

Installation OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 4-8

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-1 Connector Pinouts 5 5.0 OMS11 External Interface Connections All OMS11 exte

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-2 5.1 LED Indicators There are nine (9) Light Emitting Diodes (LED’S) on t

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-3 Table 5-4. DC Power A – VDC B + VDC C Ground D N/C 5.3 Ground Lug An

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-4 Connection to the terminal device. This is the standard configuration when

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-5 H Ground GND --- J Switch Fault – C SF-C --- K Switch Fault – NC SF-NC

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-6 Fault detection with the OM20 supplying power to BUC: • BUC Faults - OM20

OMS11 1:1 Redundancy Switch Preface TM133 – Rev. 1.1 v Preface P This manual provides installation and operation information for the Radyne OM

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-7 5.5 Terrestrial Data Interface (J7) – RS422 Synchronous Data, Asynchronous Ove

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-8 Table 5.6 cont. RS422 Synchronous Data I/O; Async Data Connector (J7) J7

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-9 5.6 Modem A Data Interface (J1) – RS422 Synchronous Data, Asynchronous Overhea

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-10 Table 5.8 cont. RS422 Synchronous Data I/O; Async Data Connector (J1) J1

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-11 5.7 Modem B Data Interface (J13) – RS422 Synchronous Data, Asynchronous Overh

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-12 Table 5-10 cont. RS422 Synchronous Data I/O; Async Data Connector (J13) J1

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-13 5.8 Modem A Remote/Terminal/Fault Port on OMS11 (J2) This port provides Faul

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-14 5.9 Modem B Remote/Terminal/Fault Port on the OMS11 (J14) This port prov

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-15 Table 5-154 CAR5904 OMS11 TO SECTOR MICROWAVE W/G SWITCH CONNECTOR OMS11 J5 /

Connector Pinouts OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 5-16 Figure 5-3. Pinout for Sector Microwave Switch 5.11 Mating Connectors

Preface OMS11 1:1 Redundancy Switch vi TM133 – Rev. 1.1 A note icon identifies information for the proper operation of your equipment, includin

OMS11 1:1 Redundancy Switch Connector Pinouts TM133 – Rev. 1.1 5-17

OMS11 1:1 Redundancy Switch Maintenance and Troubleshooting TM133 – Rev. 1.1 6-1 Maintenance and Troubleshooting 6 6.0 Basic Troubleshooting

Maintenance and Troubleshooting OMS11 1:1 Redundancy Switch 6-2 TM061 – Rev. 2.0

OMS11 1:1 Redundancy Switch Technical Specifications TM133 – Rev. 1.1 7-1 Technical Specifications 7 7.0 Introduction This section defines t

Technical Specifications OMS11 1:1 Redundancy Switch 7-2 TM133 – Rev. 1.0 7.6 Front Panel Controls Enable Select Auto Modem Select A Modem Sel

OMS11 1:1 Redundancy Switch Technical Specifications TM133 – Rev. 1.1 7-3

OMS11 1:1 Redundancy Switch Appendix A TM133 – Rev. 1.1 A-1 OMS11 DIP Switch Configuration A The OMS11 has four internal DIP switches that ar

Appendix A OMS11 1:1 Redundancy Switch A-2 TM133 – Rev. 1.1 Table A-1. Baud Rate Switch P

OMS11 1:1 Redundancy Switch Preface TM133 – Rev. 1.1 vii

OMS11 1:1 Redundancy Switch Appendix A TM133 – Rev. 1.1 A-3 When Jumpers are set for SOFT, this allows user to set the Baud and Unit Addresse

Appendix A OMS11 1:1 Redundancy Switch A-4 TM133 – Rev. 1.1 Figure A5. JP1 on AS/3436-6 Figure A5 illustrates the standard jumper block for c

OMS11 1:1 Redundancy Switch Appendix A TM133 – Rev. 1.1 A-5

OMS11 1:1 Redundancy Switch Appendix B TM133 – Rev. 1.1 B-1 OMS11 Remote Communications B B.0 Host Computer Remote Communications Control

Appendix B OMS11 1:1 Redundancy Switch B-2 TM133 – Rev. 1.1 The stop bits, S1 and S2, are each a mark. Data flow remains in a hold mode until S2

OMS11 1:1 Redundancy Switch Appendix B TM133 – Rev. 1.1 B-3 02h + FOh + 2Ah + 09h + 03h + DFh + FEh = 305h. Since the only concern is the modu

Appendix B OMS11 1:1 Redundancy Switch B-4 TM133 – Rev. 1.1 If a command packet is sent and not received at its intended destination, a timeout c

OMS11 1:1 Redundancy Switch Appendix B TM133 – Rev. 1.1 B-5 B.0.4 Global Response Operational Codes In acknowledgment (response) packets, the

Appendix B OMS11 1:1 Redundancy Switch B-6 TM133 – Rev. 1.1 B.0.6 RLLP Summary The RLLP is a simple send-and-wait protocol that automatically r

OMS11 1:1 Redundancy Switch Appendix B TM133 – Rev. 1.1 B-7 <OPCODE> = This byte identifies the message type associated with the

Appendix B OMS11 1:1 Redundancy Switch B-8 TM133 – Rev. 1.1 Opcode <2083h> Query OMS11 Backup Configuration Query Response Data Field (1 b

OMS11 1:1 Redundancy Switch Appendix B TM133 – Rev. 1.1 B-9 <1> Switch Delay Demod NoFault LSB Opcode <2087h> Query OMS11 Switch

Appendix B OMS11 1:1 Redundancy Switch B-10 TM133 – Rev. 1.1 Bit 3: 1 = Force Demod A Alarm Enabled Bit 4: 1 = Mod B Alarm Enabled Bit 5: 1 = For

OMS11 1:1 Redundancy Switch Appendix B TM133 – Rev. 1.1 B-11

OMS11 1:1 Redundancy Switch Interconnecting Cable Drawings TM133 – Rev. 1.1 C-1 Interconnecting Cable Drawings C The following drawings are i

OMS11 1:1 Redundancy Switch Interconnecting Cable Drawings TM133 – Rev. 1.1 C-3

OMS11 1:1 Redundancy Switch Table of Contents TM133 – Rev. 1.1 1 Table of Contents ToC Section 1 - Introduction ...

OMS11 1:1 Redundancy Switch Interconnecting Cable Drawings TM133 – Rev. 1.1 C-5

OMS11 1:1 Redundancy Switch Interconnecting Cable Drawings TM133 – Rev. 1.1 C-7

OMS11 1:1 Redundancy Switch Glossary TM133 – Rev. 1.1 G-1 Glossary G A A Ampere AC Alternating Current ADC Analog to Digital Converter AG

Glossary OMS11 1:1 Redundancy Switch G-2 TM133 – Rev. 1.1 C C Celsius CATS Computer Aided Test Software CA/xxxx Cable Assembly CD-ROM Compact

OMS11 1:1 Redundancy Switch Glossary TM133 – Rev. 1.1 G-3 F F Fahrenheit FAS Frame Acquisition Sync. A repeating series bit, which allow ac

Glossary OMS11 1:1 Redundancy Switch G-4 TM133 – Rev. 1.1 K Kbps Kilobits per Second Kbps Kilobytes per Second kg Kilogram kHz Kilohertz Ksps

OMS11 1:1 Redundancy Switch Glossary TM133 – Rev. 1.1 G-5 R RAM Random Access Memory RF Radio Frequency ROM Read Only Memory rms Root Mean

Glossary OMS11 1:1 Redundancy Switch G-6 TM133 – Rev. 1.1 W X Y Z W Watt Misc. µs Microsecond Ohms Ohms 16QAM 16 Quadrature Amplitude Modula

Introduction OMS11 1:1 Redundancy Switch TM133 – Rev. 1.1 2 Section 4 - Installation ...............