Comtech-ef-data KST-2000L Bedienungsanleitung

KST-2000LSatellite Terminal SystemInstallation and Operation ManualPart Number MN/KST2000L.IOM Revision 2

Preface KST-2000L Satellite Terminal System Metric Conversion Metric conversion information is located on the inside back cover of this manual. This

KST-2000L Satellite Terminal System Preface EMC Compliance This is a Class A product. In a domestic environment, it may cause radio interference that

Preface KST-2000L Satellite Terminal System Safety Compliance EN 60950 This equipment meets the Safety of Information Technology Equipment specifica

KST-2000L Satellite Terminal System Preface Warranty Policy This Comtech EF Data product is warranted against defects in material and workmanship for

Preface KST-2000L Satellite Terminal System xii Rev. 2

Chapter 1. INTRODUCTION This chapter provides a description and the specifications for the KST-2000L satellite terminal system. The terminal system

Satellite Terminal System Revision 2 Introduction MN/KST2000L.IOM 1.1 Description The KST-2000L satellite terminal system is a high-performance tran

Satellite Terminal System Revision 2 Introduction MN/KST2000L.IOM 1.1.3 Features Refer to Table 1-1 for KST-2000L features. Table 1-1. Features P

Satellite Terminal System Revision 2 Introduction MN/KST2000L.IOM 1.1.4 KST-2000L System A block diagram of a single thread configuration, the sys

Satellite Terminal System Revision 2 Introduction MN/KST2000L.IOM The M&C remote control, whose operation is described in Chapter 3, is used t

Satellite Terminal System Revision 2 Introduction MN/KST2000L.IOM 1–6 This page is intentionally left blank.

Chapter 2. Specifications 2.1 Summary of Specifications Table 2-1. Transmit Specifications Input Characteristics: Frequency Range 50 to 90 MHz,

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM Table 2-1. Transmit Specifications (Continued) Spurious Signals: Sig

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM 2.1.1 Solid-State Power Amplifier (SSPA) 2.1.1.1 SSPA Monitor a

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM 2.1.2 Interface Requirements 2.1.2.1 M&C Interface The M&C of

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM Table 2-5. M&C Functions/Parameters Pin Signal Description

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM 2.1.3 Internal Data Interface The individual RF uplink and downlink

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM 2.3 Environment Specifications Table 2-8. Converter Unit and SSPA

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM 2.4 CE Certification Table 2-9. CE Certification Specification De

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM Table 2-10. Part Numbers for Various Equipment (Contd) Part Number

KST-2000L Satellite Terminal System Installation and Operation Manual Comtech EF Data is an ISO 9001 Registered Company. Part Number MN/KST2000L.

Satellite Terminal System Revision 2 Summary of Specifications MN/KST2000L.IOM 2–10 This page is intentionally left blank.

Chapter 3. Connector Pinouts This chapter provides system equipment and external connections information. Refer to Chapter 6 for installation proced

Satellite Terminal System Revision 2 Connector Pinous MN/KST2000L.IOM 3.1.2 Description of Options Table 3-1 lists the various equipment options,

Satellite Terminal System Revision 2 Connector Pinouts MN/KST2000L.IOM 3.2 Electrical Connections 3.2.1 Converter Unit The external connections on

Satellite Terminal System Revision 2 Connector Pinous MN/KST2000L.IOM Table 3-3. Converter Unit External Connections Ref. Des. Name Connector Typ

Satellite Terminal System Revision 2 Connector Pinouts MN/KST2000L.IOM 3.2.1.2 Remote Connector (J2) The Remote Connector (J2) is a 26-pin, circu

Satellite Terminal System Revision 2 Connector Pinous MN/KST2000L.IOM 594832167GNDCTSRD/RRTSTD/TDSREIA-232 ADAPTER CABLEJPEFGHComtech EF Data: CN/S

Satellite Terminal System Revision 2 Connector Pinouts MN/KST2000L.IOM 3.2.1.6 RF OUT Connector (J6) The RF OUT connector (J6) is a type N, fema

Satellite Terminal System Revision 2 Connector Pinous MN/KST2000L.IOM 3–8 The 2 and 4 Watt SSPAs have a Type N, female (50Ω) connector (J1) at one e

Chapter 4. OPERATION This chapter describes the procedures for initial testing of a KST-2000L system, and de-scribes each major system function. 4.1

Customer Support Contact the Comtech EF Data Customer Support Department for: • Product support or training • Information on upgrading or returnin

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM Note: Ensure that the termination selected for the HPA output is sized to handle th

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM 5. Turn the RF output of the up converter ON. See appendix B.3 system configura-t

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM 6. The system is ready for final installation to the antenna feed. Perform the rest

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM The UART supports serial asynchronous communication (remote port) with a maximum d

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM 4.3 Up Converter Description The up converter accepts a 70 MHz (140 MHz) IF input s

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM 72 MHZREFL0 316.830GHZ13.750 t o14.500 GHZ2330-3080 MHZ Figure 4-4. S to Ku-Band

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM 4.5 Automatic Gain Control (AGC) The KST-2000L incorporates a closed-loop Automatic

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM 4.5.2 Fault and Error Response Table 4-1 shows how the AGC system reacts to power

Satellite Terminal System Revision 2 Operation MN/KST2000L.IOM 4–10 -50 -45-40-35 -30-25-20Allowed IF Input Power Range,dBmAllowed Up ConverterAtte

Chapter 5. FAULT INDICATION AND ISOLATION This section describes fault indication and isolation methods for the KST-2000L system. Routine maintenan

Table of Contents Customer Support ...

Satellite Terminal System Revision 2 Fault Indication and Isolation MN/KST2000L.IOM 5.2 Fault Isolation System faults are reported on the fault

Satellite Terminal System Revision 2 Fault Indication and Isolation MN/KST2000L.IOM Table 5-1. KST-2000L Fault Tree RF OUTPUT

Satellite Terminal System Revision 2 Fault Indication and Isolation MN/KST2000L.IOM 5–4 Table 5-2. KST-2000L Fault Tree (Continued)

Chapter 6. EQUIPMENT MOUNTING This chapter describes the mounting instructions for the KST-2000L unit. Installation procedures and hardware kits ha

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6.1 Tools Required Qty. Description 1 1 1 1 1 1 3/8” drive ratchet. Adjus

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6.2.1.2 Converter Spar Arm Mounting Instructions 1. Position the Converter

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6.2.2 Pole Mount 6.2.2.1 Optional Pole Mount Installation Kit for Converte

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6.2.2.2 Converter Round Pole Mounting Instructions 1. Position the conver

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 4. Position two spring nuts in each of the Unistrut channels mounted to the

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM Figure 6-5. Front View of Converter Installed on Round Pole 6.2.2.3 Conv

Preface KST-2000L Satellite Terminal System 3.1 System Equipment Information ...

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6.3 SSPA Installation 6.3.1 Feed Mount Offset Antenna The information in t

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM Figure 6-6. Installing the SSPA 6–9

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6.4 LNB Installation 6.4.1 Feed Mount Offset Antenna 6.4.1.1 Optional Fee

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6.4.1.2 LNB Feed Mount Offset Antenna Installation Instructions To install

Satellite Terminal System Revision 2 Equipment Mounting MN/KST2000L.IOM 6–12 This page is intentionally left blank.

Chapter 7. TERMINAL MODE COMMANDS This chapter defines the protocol and command structure for remote control and status monitoring of the KST-2000L

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM The general message structure is as follows: • Start Character • Device

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM 7.2.3 Command/Response The command/response portion of the message cont

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM 7.3 System Configuration Commands The commands and responses for setti

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM Preset Configuration Clear Command Response Status Response <add/

KST-2000L Satellite Terminal System Preface CHAPTER 7. TERMINAL MODE COMMANDS ... 7–1 7.1 Gene

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM 7.5 LNB Commands Commands and responses to control and to determine the

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM 7.7 Miscellaneous Commands Miscellaneous commands and responses for rese

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM 7.8 Fault Commands The internal M&C stores up to 10 faults of eac

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM Reference Current Faults Command Response <add/RS_'cr' &g

Satellite Terminal System Revision 2 Terminal Mode Commands MN/KST2000L.IOM 7–10 ADAP 2 and 4 Watt SSPA Stored Faults Command Response <add/HSF

Appendix A. EQUIPMENT OUTLINE DRAWINGS This section contains the equipment outlines for the following components: • 2 and 4 Watt SSPA • KST-20

Satellite Terminal System Revision 2 Equipment Outline Drawings MN/KST2000L.IOM A.1 2 and 4 Watt SSPA Equipment Outline 8.72#8-32 UNC-2A GND STUDK

Satellite Terminal System Revision 2 Equipment Outline Drawings MN/KST2000L.IOM WR75 WAVE GUIDE#6 HARDWARE THRU1.041.122X 0.812X 2.893.006.0010.96

Satellite Terminal System Revision 2 Equipment Outline Drawings MN/KST2000L.IOM A.2 KST-2000L Converter Equipment Outline RX M ONJ5ERDEGNDREM OTE

Satellite Terminal System Revision 2 Equipment Outline Drawings MN/KST2000L.IOM A.3 Ku-Band LNB Equipment Outline 5.67 (143.8)5.12 (130.0)2.55 (

Preface KST-2000L Satellite Terminal System Figures Figure 1-1. KST-2000L...

Satellite Terminal System Revision 2 Equipment Outline Drawings MN/KST2000L.IOM A–6 This page is intentionally left blank.

METRIC CONVERSIONS Units of Length Unit Centimeter Inch Foot Yard Mile Meter Kilometer Millimeter 1 centimeter — 0.3937 0.03281

2114 WEST 7TH STREET TEMPE ARIZONA 85281 USA 480 • 333 • 2200 PHONE 480 • 333 • 2161 FAX

KST-2000L Satellite Terminal System Preface Overview of Changes to Previous Edition A summary of the changes made for Rev. 2 includes: Chapter 2 Up